![]() ![]() ( I have actual added the height and length of the Panel a few times to make sure a cable could reach anywhere in a panel).Īnd I guess the last thing you wanted to know was for the Integration between AutoCAD Electrical and Inventor. If you asking what the best practice I would say add a foot on each end. So no formula to share since their isn't any. That is setup in inventor not ACADE, and its not available unless you export the inventor data back into AutoCAD Electrical at which point it auto assigns the wire length based on the information from inventor. ![]() (AB and Eaton Released add-on packs for the addational content you can find it on the autodesk website)Īs for wire length calculations, I assume you mean the Extra % of wire added to the wire length from Inventor in the cable and harness section. If its the full library in ACADE, you select the manufacturers during installation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |